Industrial Cleaning Products

Accell Clean® Adhesive Remover

Accell Clean® Adhesive Remover is specifically formulated to remove the residue left when adhesives are removed.

Applications

Use one full trigger squeeze of Accell Clean® Adhesive Remover per every 1 linear foot of affected area to be cleaned. Allow the cleaner to set for approximately 10 seconds. After the cleaner has set on the affected area, wipe the cleaning solution off using a 3M Paint Stripper Pad. Repeat steps over the same affected area, as necessary, to clean dirt and stains. Wipe with a damp cloth or paper towel.

Storage and Handling

Accell Clean® Adhesive Remover does not need to be handled with any personal protective equipment. Keep container tightly closed until ready for use. Store in cool, well ventilated place that is locked. It is advised to avoid freezing. Dispose of contents/container in accordance with local/regional/national/international regulations. Do not reuse empty container. Accell Clean® Adhesive Remover has a shelf life of 2 years.
Typical Properties
Appearance Homogenous, light amber liquid
pH 5.0 – 7.0
Specific Gravity @ 25°C 1.00 – 1.02
Density, lbs/U.S. gal 8.33 – 8.50
Flash Point >108.9°C (>228°F)
Percent Volatile (15 min @ 105°C)     90 – 95
Boiling Point >202°C (>395.6°F)
Lower Interfacial Tension (IFT) and Critical Micelle Concentration (CMC) improve cleaning potential compared to standard cleaning products
Accell Clean® Adhesive Remover is a registered trademark of Advanced BioCatalytics.